Please give it another try! If you have any question about your setup or anything else, please shoot us an email at questions@vanturtle.com! You can save your customizations by bookmarking the current URL, so you don't have to select everything again.
| VanTurtle PCB | €9,99 |
| Total | €9,99 |
What do you want to control?
Choose what port you want hand soldered in the primary slot on the left side of the board.
Uses a black Ethernet (RJ45) jack on the side of the fan
Uses a smaller phone port (RJ11/RJ25) to communicate
Some inverters come with a phone jack for a wired control
No soldered port whatsoever, truely DIY
Anything else you want to control?
What do you want soldered in the secondary slot on the right side of the board?
Uses a black Ethernet (RJ45) jack on the side of the fan
Uses a smaller phone port (RJ11/RJ25) to communicate
Use an Ethernet cable to switch up to 1amp loads anywhere in your van
Some inverters come with a phone jack for a wired control
If nothing above seems useful
Would you like to have screw terminals?
Screw terminals make it much easier to connect the board to your microcontroller
Easy wire connection that's extremely vibration resistant
There are pads on the board without solder paste
Would you like DuPont connectors?
Also known as Berg connectors, jumper wires or just pin headers. Enables more advanced features like connecting another I2C sensor, changing the address or using the raw IO pins of the controller.
Get the most tweakability out of the controller with 3 blocks of 6 pins
You can solder pins on yourself as well
Where would you like it shipped?
Does not have to be your home address, we can ship wherever your van is.
Includes EU, EEG and UK
Anywhere USPS delivers
If Canada Post can reach you you're good
All addresses served by Australia Post and NZ Post
But not Iran or Russia
How do you want it shipped?
Note that for untracked post we cannot issue refunds for lost packages as we cannot know if they were received or not.
One second, just redirecting you to the checkout...
